How Do I Replace My SawGear Circuit Board? - TigerStop

Changing a SawGear Circuit Board

Step One:

Remove screws on each side of Powerhead case (there is one under the latch on each side as well)

SG clamshell 1

 

Step Two:

Separate the two halves (clamshell design)

SG clamshell 2

 

Step Three:

Unscrew Two Screws

Disconnect wiring connections

Snap PCB off of Tabs

Reverse Process to install new PCB

SG-CB-image

 

Key:

A – Motor Power Wires

B – Encoder Cable

C – Power Molex Connector

D – KPM Ribbon Connector