arrow-L-teal.jpg Part List Menu

Tail Cut flag-cdn-qc-35.jpg flag-mx-35.jpg

Tail Cut is a global parameter applied to all push feed and pattern part lists that have designated the use of global head and tail cuts.

The tail cut is material removed from the trailing end of a board, not included in Clear Length, to square up the last Piece (finished part) and remove potential end Defects (splits).

Set point part lists are NOT affected by this parameter.

plist-tailcut-300-E.JPG

  1. To change the length of the tail cut, enter the desired length.

  2. Press OK-50.jpg to save it and advance to the next parameter, Outfeed, or…

  3. Press [D] to save selection and exit to the Ready Screen.

Set tail cut to its minimum length of 0.000" to turn this parameter OFF.

Maximum tail cut length is 20.000". Default value is 1.000".