arrow-L-teal.jpg Part List Menu

Retract Offset flag-cdn-qc-35.jpg flag-mx-35.jpg

Retract Offset is a global parameter applied to all push feed and pattern part lists, as well as manual movements.

This parameter functions with Retract, being used in systems in which the material moves during the process. The value of Retract Offset should be set to bring the stop back to its original position before it retracted. Retract Offset does not affect the position to which the stop pushes the material on its next move. If no retract takes place, the Retract Offset parameter is ignored.

Set point part lists are NOT affected by this parameter. Changed to include set point on version 5.03.

plist-retoffset-300-E.JPG

  1. To change the length of the retract offset, enter the desired length.

  2. Press OK-50.jpg to save it and advance to the next parameter, Load Offset, or…

  3. Press [D] to save selection and exit to the Ready Screen.

arrow-R-teal.jpg Retract Offset is DISABLED if TigerStop is NOT used with an interconnect.

arrow-R-teal.jpg Default retract offset value of 0.000" turns this parameter OFF.

Minimum retract offset value is -10.000". Maximum retract offset value is 10.000"