arrow-L-teal.jpg Part List Menu

Opti Penalty flag-cdn-qc-35.jpg flag-mx-35.jpg

The Opti Penalty parameter configures the optimizer to "penalize" multi-board Solutions.

This parameter affects only optimized part lists.

A lower value results in faster optimization using boards with shorter average length.

A higher value results in slower optimization using boards with longer average length.

plist-optpen-300-E.JPG

  1. To change the opti penalty value, enter the desired length.

  2. Press OK-50.jpg to save it and advance to the next parameter, Clamp1, or…

  3. Press [D] to save selection and exit to the Ready Screen.

Minimum Opti Penalty value is 0.000. Maximum Opti Penalty value is 100.000.

Default Opti Penalty value is 1.000.