arrow-L-teal.jpg Part List Menu

Load Offset flag-cdn-qc-35.jpg flag-mx-35.jpg

See also Full Retract, version 5.30

Load Offset is a global parameter applied to all push feed and pattern part lists.

Simply put, load offset is the amount of space that is needed to safely load material in front of a fully retracted pusher. The length of load offset is added to the Stock Length, and the stop moves to the resulting position during the loading phase.

Set point part lists are NOT affected by this parameter.

plist-loadoff-300-E.JPG

  1. To change the length of the load offset, enter the desired length.

  2. Press OK-50.jpg to save it and advance to the next parameter, Unload, or…

  3. Press [D] to save selection and exit to the Ready Screen.

Default load offset value of 0.000" turns this parameter OFF.

Minimum load offset value is 0.000". Maximum load offset value is 200.000".