arrow-L-teal.jpg Part List Menu

Clamp 1 flag-cdn-qc-35.jpg flag-mx-35.jpg

Clamp 1 is the parameter that triggers the swing clamp to activate.

This parameter should be set to equal the distance from the zero point that the material must reach to activate the swing clamp. The swing clamp will not activate until the material reaches this position.

Clamp 1 is a global parameter applied to push feed and pattern part lists only.

plist-clamp1-300-E.JPG

  1. To change the trigger position of clamp #1, enter the desired length.

  2. Press OK-50.jpg to save it and advance to the next parameter, Clamp2, or…

  3. Press [D] to save selection and exit to the Ready Screen.

Minimum Clamp 1 value is 0.000".

Default Clamp 1 value is 5.000".