Follow the below instructions to begin using TigerLink:
Click on the TigerLink Shortcut on the desktop.
The first time TigerLink is ran, the Status will display
Tiger Not Found. Select the proper comm
port setting from the pull down Comm menu and
TigerLink will search for the TigerStop again.
See example video in establishing connection with
the controller.
To start a new link, select LinkWizard.
To view the video demonstration of the Link Wizard, click here. Follow the instructions.
Organizing and Sorting Your Cut List
Once the Link Wizard has completed the link, the cut list should be organized and sorted in the Data Manager.
Keep the following items in mind when selecting descriptors for the designated rows.
Length, Quantity and Material fields are mandatory.
Material Fields will allow sorting of cuts into separate, different aspects of the cut
list. For example, width, height, maple, oak, etc.
If you do not have a printer linked to the TigerStop, disregard the Print Order and Header columns.
The data for each file type is only sorted once. Afterwards, every file using the same link follows the established parameters.
To view the video demonstration of sorting the information in Data Manager click here
After saving the data in Data Manager, the data can be downloaded from Job Manager. The Job Manager groups the multiple lines of data and will send the information to a designated cut list number, viewable in the TigerStop controller.
To view the final video in downloading a cut list to the controller click here.
Questions? Contact TigerStop Technical Support