Insert the Clipboard CD into your CD-ROM drive.  The CD should autorun and start the installation, if it does not simply double click on my computer and then right click on your CD-ROM drive and choose explore and then double click on the Setup Icon.

 

 

 

Click Next

 

Carefully Read the terms of the License Agreement and Select "I accept the terms in the Licensing Agreement" if you agree and "I do not accept the terms of the Licensing Agreement" if you do not agree to the terms.  If you choose I do not accept the terms, installation of Clipboard will not continue.  Click Next.

 

Choose your installation destination.  By default, Clipboard will install to your Program Files directory.  If you want to install Clipboard to a different directory, click the browse button and browse to the folder you wish to install Clipboard to.  Click Install

 

Clipboard will copy all the necessary files to their respective locations and then ask if you wish to install the TigerServer.

 

Click Yes to install the TigerServer

 

Once the TigerServer has been installed, Click finish to Complete Installation.  You can also choose to run Clipboard if you check the box marked Run Clipboard 5.0.

 

Clipboard is designed to be ran on a system with a screen resolution of 1024x768.  If you are running a screen resolution higher or lower than 1024x768, Clipboard will not display properly.  

 

Now that Clipboard is installed, its time to run it.  If you did not select to Run Clipboard 5.0 after installing, double click on the Clipboard Icon on your Desktop.

 

When Clipboard starts for the first time, you will see a message asking you to enter your enable code.  This enable code is obtained from the back of your Clipboard CD case, or by contacting TigerStop Customer Service.

 

Enter Your 20 Digit Enable code and click the Accept button.

 

After entering your enable code and clicking Accept, the main Clipboard screen will appear and Clipboard will begin trying to connect to your TigerStop.

 

By default, Clipboard will attempt to connect to the TigerStop on your first available COM port.  For the example, COM1 is the only available port.  If Clipboard fails to connect as it may have the wrong COM port selected, simply select the right comport and then click the Connect button in the lower right hand corner.

 

 

Once Connected, the Main Clipboard Screen Should appear.

You can now use the Clipboard Software.  Simply enter in a dimension like you would on the TigerStop controller and hit start.  TigerStop should move to the position entered.

 

Congratulations.  Enjoy your new Clipboard Software.