TigerStop Manual
The basic TigerStop consists of 7 components:
The motor box, blue anodized aluminum. There is a warning sticker on the motor box end cap.
Red Power ON/OFF switch.
The flip-away stop, aluminum, yellow powder-coated, with safety label.
This component is shipped with its fastening hardware in the accessory box and must be attached at installation.
The controller, aluminum, yellow powder-coated, with bright green keypad face and colored buttons.
The trim strips, orange plastic strips that fill the T-slots on 2 sides of the fence beam.
The end cap, blue anodized aluminum with a tensioning bolt in the center, over which there is a label to prevent tampering.
DO NOT remove the label or loosen the tensioning bolt! As the label says, "Removal will VOID the warranty."
The serial number, which is stamped into the metal of the fence beam on the forward face at the far end.
What next?Go back and fill out the warranty registration and get my enable code.
Got my enable code already, time to…