The Basic Heavy Duty 2

The basic Heavy Duty 2 (HD2) consists of 5 major components:

Fig. 2

Fig. 4

The HD2 Heavy Duty 2 carriage (Fig. 1) containing the motor and gear box. The carriage moves along the fence beam by rack and pinion drive.

The HD2 amplifier enclosure (a TigerStop motor box, no motor inside) with its mounting bracket (Fig. 2). This should be mounted to a support structure (e.g., feed table) at the far end the end of the TigerStop fence beam farthest away from the motor box, opposite of motor end, a physical designation of the TigerStop; on an HD2, the far end is where the access portals are located, opposite the tool end of HD2.
The HD2 pusher arm (Fig. 3), mounted to the carriage.
The controller keypad and stand (Fig. 4).
The HD2 fence beam (Fig. 5) containing the cable chain (Fig. 7). The beam is built up from several joined pieces (Fig. 8) and is faced with ¼" steel plates on the working side. The rack (Fig. 9) is mounted to the back side, along with the beam limit stops (one at each end, Figs. 10-11).

The serial number is stamped into the metal of the fence beam between the access portals at the far end.

Serial Number Location

The serial number is stamped into the metal of the fence beam between the access portals at the far end (Fig. 6).

Fig. 6

Fig. 7

Fig. 8

Fig. 9

Fig. 10

Fig. 11