TigerStop Manual 4.72
Auto-Test should be run any time a new drive belt is installed on a TigerStop.
Running auto-test requires that you choose two positions, one near the
motor and the other near the far end, and program these two positions
alternately into the first 10 hot keys another name for the GoSet function, which stores programmable lengths
behind key combinations 1 to 99.
When auto-test is run, the stop will travel between these two positions
until you press the STOP button.
RIP FENCE Specific:
When running auto-test on a TigerRip Fence, the compressed air supply
must be connected to the machine!
How to set up Auto-Test
At the Ready screen
press 
to start entering the “hot keys.” For
a complete run down on how to program and use "hot keys", see
Making
Hot Keys
.
Use 8" and 50" as the near and far positions.
To run auto-test for your machine, choose as the far position a length at the far end of your TigerStop instead of 50" as in this example.
To run auto-test on a metric TigerStop, you can use 200mm and 1270mm, approximate metric equivalents of the positions used in this example.
Press 
to enter the first
(near) length and then 
to view it 
.
Press 
to advance to the next hot key.
Press 
to enter the next (far) length and then to view it 
.
You can automatically advance to the next hot key by
pressing after
each entry.
Now, program hot
keys 3 to 10 alternately
with 8" and 50" as above,
and then press to
save them and exit the "hot keys" program.
Auto-test will NOT run correctly unless ALL 10 hot keys are programmed!
