Program
Any Cut ListTigerStop Manual 4.72
Programming Set PointPress 
To program an optimized
set point cut list, press . To program a non-optimized
set point cut list, press 
.
Enter the lengths and pieces per length that are in your set point cut list, starting at Cut#1, and continue entering lengths and pieces per length to the end of the cut list.
… 
After entering the last length and quantity (in the
example the next cut is Cut#42), press 
to exit programming mode and advance to 
.
To run the set point cut list
NOW, press . Click 
to link to Running a Set Point Cut List. To exit the set point cut
list you just programmed and save it, press .
You are now back at the Ready screen. Your
set point cut list is saved. You can run it at any time in the future.
See also…
