Program
Any Cut ListTigerStop Manual 4.72
Programming Push FeedPress 
To program an optimized push feed cut list set point or push feed cut list which is run in optimize mode, which
divides each available Clear Length into finished parts with the least
amount of Waste,
press . See Optimized
Push Feed for further information. To program a non-optimized
push feed cut list, press 
. Optimized
and non-optimized cut lists are programmed the same way.
To program local head and tail cuts front and back end trims, set for the current cut list ONLY,
press . Click 
to link to the next step… To select global head and tail cuts front and back end trims, set by parameters in the Operation menu, and
applicable to ALL cut lists,
press .
At 
enter the lengths and pieces per length
that are in your push feed cut list, starting at Cut#1:
In this example, there are only 3 lengths in the cut list (12" x 3 pcs, 18" x 6 pcs and 9" x 12 pcs).
After each length is entered, the cursor moves to the right to let you enter the number of pieces at that length. Following is what the screen looks like as the lengths and pieces are entered…
After entering the third length and quantity, since
it is the last length in the pattern, press to exit programming mode and advance to .
To run the push feed cut list
NOW, press . Click
to link to Running a Push Feed Cut List. To exit the push feed cut
list you just programmed and save it, press .
You are now back at the Ready screen 
. Your push feed cut list is saved. You can
run it at any time in the future.
See also…
