Program
Any Cut ListTigerStop Manual 4.72
Programming
PatternPress 
To program local head and tail cuts front and back end trims, set for the current cut list ONLY,
press 
. Click 
to link to the next step… To select global head and tail cuts front and back end trims, set by parameters in the Operation menu, and
applicable to ALL cut lists,
press 
.
Enter the length of your stock
and press 
.
The top line of the display shows the stock length MINUS the head and tail cuts. The bottom line shows Cut#1. Enter the lengths and pieces per length that are in your pattern:
In this example, there are only 3 lengths in the pattern. After each length is entered, the top line of the display shows how much of the stock length remains after subtracting the head and tail cut, and one of each length entered so far.
Enter cut#1 length and
.
Enter number of pieces and 
Enter cut#2 length and . Enter number of
pieces and 
Enter cut#3 length and . Enter number of
pieces and 
After entering the third length and quantity, since
it is the last length in the pattern, press to exit programming mode and advance to .
To run the pattern cut list
NOW, press . Click
to link to Running a Pattern Cut List. To exit the pattern cut list
you just programmed and save it, press
.
You are now back at the Ready screen. Your
pattern cut list is saved. You can run it at any time in the future.
