Program Any Cut List

Cutlist#22 is used in the examples. You can substitute any cut list number between 1 and 99.

Press the controller keys shown in the steps below…

• An arrow after a key sequence points to the screen display after pressing the key(s).

Programming a cut list is a path with many "forks" or decision points.

• Clicking on a link arrow at a decision point will link you to the next step.

Press for a push feed cut list TigerStop cut list method where material is push fed by the TigerStop into the saw and the finished parts come out on the outbound side of the saw blade.

Click to link to the next step…

Press for a pattern cut list TigerStop cut list method where consistent stock lengths are push fed through a saw to produce repeating sets of finished parts.

Click to link to the next step…

Press for a set point cut list TigerStop cut list method where material is manually fed into the saw toward the TigerStop and the finished parts come out between the flip-away stop and the saw blade.

Click to link to the next step…