TigerStop feed table design makes mounting
a TigerStop easy. No special brackets are needed. TigerStop is mounted
directly to the table top! If you are mounting TigerStop to an existing
table, use Brackets.TigerStop Manual
TigerStop feed table design makes mounting
a TigerStop easy. No special brackets are needed. TigerStop is mounted
directly to the table top! If you are mounting TigerStop to an existing
table, use Brackets.
Your feed table should be set up. Installing
Feed Tables has complete instructions, if you still need to set up
your TigerStop feed tables.
On your TigerStop feed table…
Place TigerStop on the table top with the motor facing UP and next to your saw or other tool.
Standing in front of the table, pull the fence beam toward you, so the slotted mounting holes are visible in the table top BEHIND the fence beam.
Insert the T-nuts into the T-slots and slide them down to line up with the slotted mounting holes.
Carefully rotate TigerStop so the motor faces to the BACK and the T-nuts are OVER the slotted mounting holes.
Place a washer on each bolt, insert the bolts from underneath the table, and hand-tighten them.
Roller-tops tables use yellow metal spacers, placed along the length of the fence beam at regular intervals, to raise TigerStop above the level of the rollers.
Line up the TigerStop fence beam with the back fence on your saw or other tool.
The slotted holes in the table top let you line up TigerStop accurately.
If your tool is a saw, make sure that TigerStop is square to the saw blade.
When your TigerStop is in alignment, finish tightening all the bolts.
CAUTION! Washers MUST be used to prevent damage to the
fence beam by over-tightening!