Calibrate TigerStop to set its distance
from zero. Calibrate whenever the saw blade is changed, or when you add
or remove a stop attachment, such as a gangstop
or pusher foot.TigerStop Manual
Calibrate TigerStop to set its distance
from zero. Calibrate whenever the saw blade is changed, or when you add
or remove a stop attachment, such as a gangstop
or pusher foot.
From a position at least 12" out,
enter a length of 10".
Press 
.
The stop moves inbound to a position 10" from the saw blade.
Cut a piece of stock at this length and carefully measure it.
It should be right on 10". If it is accurate, no need to calibrate.
Be sure to use an accurate measuring tool. TigerStop can be only as accurate as you make it!
If the sample cut measured 10¼"
instead of 10"…
