TigerStop Manual
If you have up to 99 lengths that you
cut frequently, you can have TigerStop "remember" them. The
number keys from 1 to 99 become hot keys another name for the GoSet function, which stores programmable lengths
behind key combinations 1 to 99
to access lengths quickly without having to key in long numbers. This
will speed up TigerStop operation significantly.
You cannot hot key to a value of zero.
Your hot keys have to start with 1, and you cannot skip a hot key number.
If you are using 12 hot keys, for example, program keys 1 through 12.
You can use Cut List Jump to get around when re-programming hot keys.
Make hot keys for three common lengths:
12", 14½" and 17¾"
To start making “hot keys”…
Press 
to access the menu. The screen will display
and there may already be a value for GoSet#1 which is
your first hot key. On a new TigerStop, this value would have been entered
during production and testing at the factory.
Press 
to enter the first length 
, and then press 
to view it 
. You have programmed your first
hot key!
Press 
to
enter the next length, and the screen will display 
. Again,
there may already be a value there, from the factory. Enter the new value
right over the top of it!
Press 
to enter the next length, and to view it, as
before.
Press to
enter the next length.
Press 
to enter the third length and view it.
You can also press 
to go back to view
or correct a previous hot key!
Press to
save the three hot keys you just made.
