It's Time to Calibrate!

  1. Press . The M2 menu displays.

  2. Press . The M4 menu displays.

You enter the actual measured length of your sample piece at this screen.

  1. Press .

This will save the original position of 10" as 10.25", correcting the inaccuracy.

  1. Cut another sample piece using the same procedure, starting at step 1 above.

If the sample piece measures the same as the position shown on screen, TigerStop is calibrated. If it is still off, repeat the process.

If you were scaling your TigerStop manually, go back to Manual Scaling and continue at step 2.