The Motion Menu in the TigerStop
Manual has information about adjusting HD2 parameters.TigerStop Manual
TigerStop Heavy Duty 2 is, in almost every respect, exactly what it claims to be—a TigerStop with heavy duty capabilities, being able to develop 700 pounds of force or travel at up to 60" per second.
The HD2 pusher arm is bolted to the carriage, providing a 4" x 12" surface to push material to the tool.
Everything related to control and movement, cut list creation and downloading, and even set up procedure, is the same as the normal TigerStop. Follow the instructions found in this Manual. Follow the instructions found in the TigerStop Manual. Anything specific to TigerStop Heavy Duty 2 will be found in the HD2 book sections of the Installation Guide. in the TigerStop Manual.
TigerStop HD2 uses rack and pinion drive and is produced with one of three possible gear boxes in the following ratios:
15:1 — maximum velocity 23 ips — maximum load at 20 ips 3000# — approx. scale 9.548
10:1 — maximum velocity 34 ips — maximum load at 20 ips 2500# — approx. scale 6.367
5:1 — maximum velocity 64 ips — maximum load at 20 ips 1500# — approx. scale 3.183
Maximum velocities and maximum loads shown above were determined by TigerStop in extended testing of the equipment. It is recommended that the user do not exceed these limits.
Reducing the velocity increases the maximum load; increasing velocity lowers it.
Adjust the acceleration and deceleration according to your material requirements.
The Motion Menu in the TigerStop
Manual has information about adjusting HD2 parameters.
Left Hand Heavy Duty 2
HD2
LEFT Parts List
HD2 LEFT Printable PDF
HD2 RIGHT Drawing & Parts
List
HD2 Left Parts List — Next Page
