Do not randomly drill
and tap holes in the TigerStop fence beam for mounting or for any other
purpose. This might damage the drive system. All fastening or attachment
to the fence beam MUST be made by inserting T-nuts & bolts with washers.
It is CRITICAL — especially
if NOT using TigerStop attachment brackets (BR3x3) — that the bolts be
prevented from tightening through the T-nuts and into the aluminum fence
beam. Washers MUST be used!
Uneven tightening
of the bolts used to fasten down TigerStop to its mounting support can
introduce a slight twist or other deformation in the beam. This will result
in inaccurate measurement and premature failure of the drive belt or other
components.
The motor box (compartment)
contains DC voltage with potentially FATAL amperage. NEVER attempt any
unauthorized actions inside the motor box!