To use your TigerStop, you have to enable it! enter a numeric sequence at the controller which will activate the correct
software level and permit TigerStop operation
Your TigerStop warranty begins on the day that your TigerStop
is enabled!TigerStop Manual
To use your TigerStop, you have to enable it! enter a numeric sequence at the controller which will activate the correct
software level and permit TigerStop operation
Your TigerStop warranty begins on the day that your TigerStop
is enabled!
To enable your TigerStop…
Fill out the warranty
registration form and fax it to TigerStop.
TigerStop customer service will give you your machine's enable code.
Turn TigerStop ON 
. The
switch is on the motor box 
.
The screen displays…
You will see the message "Enter enable code" on the top line of the LCD screen, which alternates with two other messages: "Call TigerStop," and the factory telephone number "(360) 254-0661." The serial number of your machine is constantly displayed on the bottom line of the screen. When you enter the enable code, it will REPLACE the serial number.
Enter the enable code a series of numbers that you enter just once the first time you power
on your TigerStop, to activate it
and press
to load the code.
If the "Enter enable code" and the other messages stop blinking, the enable code has been successfully loaded (but not yet stored), so you can run the home routine, continuing at step 2 in Start Up. If the "Enter enable code" and the other messages continue to display…
If you encounter a home routine failure right after you have entered your enable code, the enable code will NOT have been stored, and it will have to be re-entered. TigerStop is not actually enabled until it has successfully run the home routine and stored the enable code.
Start
up your TigerStop NOW!
If you are upgrading to a new software level, you must enter a new enable code…
