When you are in cut list edit mode, you
can jump to any cut in a cut list without having to scroll through the
entire list..TigerStop Manual
When you are in cut list edit mode, you
can jump to any cut in a cut list without having to scroll through the
entire list..
To get into cut list edit mode…
Press 
. = "any cut list number."
Press 
to
get into edit mode.
Press 
to go directly to the cut# you want. = "any cut# programmed."
Now, you can view the cut length and quantity as well as edit it, if you want to.
You can jump to the first cut from anywhere in edit
mode by pressing 
.
You can jump to the last cut from anywhere in edit mode
by pressing 
or any number GREATER than the last cut# in your cut list.
After
editing your cut list, just press to get to 
and make your choice to run the cut list or save it and exit.
You can also use cut list jump when you
are editing your "hot keys" which are stored in Cutlist#0.
See also…