Brackets

PART#

BR3X3

Description and Use

TigerStop Brackets are available for mounting a TigerStop to an existing table or other support structure. They are NOT needed with TigerStop feed tables which are designed for direct table-top mounting.

TigerStop Brackets have slotted holes, close on one side, far on the other (Fig. 1), for adjustability. Every bracket comes with a hardware pack (Fig. 2) with enough fasteners for one bracket.

Fig. 1

How many to use

Use 2 brackets to mount a machine up to Tiger04 (6' gross length), and one additional bracket for each 2’ of machine length.

Each BR3x3 bracket is wrapped with one hardware pack taped to the inside corner (Fig. 3). The hardware pack has enough fasteners for one bracket. The hardware pack contains:

  • (2) F0110 3/8"-16 x 1" hex bolts

  • (2) F0415 3/8" UNC hex nuts

  • (2) F1500 5/16"-18 x 5/8" bolts

  • (2) F1670 5/16" washers

  • (2) F1677 3/8" washers

  • (2) F0405 5/16"-18 x .620 t-nuts

Depending on the thickness of the support structure, longer bolts of the same type as those in the nut pack may be necessary.

Installing TigerStop with Brackets

TigerStop has T-slots on all four faces of the fence beam. The T-nuts slip into routed openings at the end of the fence beam and are used to anchor it to the table with the bolts provided. When using BR3X3's to mount a TigerStop to an existing table, the brackets are first attached to the back edge of the table, and TigerStop is mounted to the brackets.

Fig. 2

Fig. 3

NEVER remove the end cap to slide in the T-nuts!

The way to slide the T-nuts into the T-slots when attaching the brackets is to insert them at the routed openings (Fig. 4). To slide T-nuts into the T-slots you have to remove the orange plastic trims from the slots. The trims can be pushed into the T-slots on one of the other faces of the fence beam.

Fig. 4