Back Rule

Adhesive Back Rule Description

The Back Rule is a self-adhesive tape measure used on the infeed table of a set point system.

Just remove the backing and carefully apply it to the Back Fence. If you are using it with the Back Fence Extender, you can bring it close to the zero point of the saw. Cut off and discard a small section at the zero end of the rule.

• Back Rules are available in inches, or in metric.

• The inch Back Rule comes in 144” length to match the Back Fence.

The metric Back Rule comes in 4 meter length (about 157”).

* The part numbers for metric rules are:    BRLR-M     BRRL-M

Back Rule Read Direction

The zero end of your set point TigerStop cut list method where material is manually fed into the saw toward the TigerStop and the finished parts come out between the flip-away stop and the saw blade infeed fence is the end closest to the saw.

In Fig. 1, the zero end is on the left side of the picture, so the rule reads from left to right, just as you read an ordinary book.

* For a left-to-right reading rule, order a BRLR.

If the zero end were on the right side of the picture, the rule would read right-to-left.

* For a right-to-left reading rule, order a BRRL.

Fig. 1