Attaching the Flip-Away Stop

The flip-away stop consists of…

• one (1) yellow powder-coated aluminum flip-away stop

• one (1) threaded rod

In Fig. 1 the threaded rod is not visible, because it is inside the carriage hinge, held in place by the lock nuts.

• 2 nylon washers

• 2 lock nuts

• 2 nylon set screws

Used to level the stop relative to the table.

Fig. 1

1. Place the flip-away stop over the fence beam and center the carriage hinge between the two ends of the stop hinge.

2. Insert a nylon washer between the carriage hinge and each end of the stop hinge (Fig. 1).

3. Slide the threaded rod through the stop-to-carriage assembly, so it passes through the hinge and the nylon washers.

4. Screw the lock nuts on each end of the threaded rod.

Make sure that the stop can be raised and lowered without difficulty (Fig. 2). It is better that the stop moves with some resistance, rather than very loosely.

5. Adjust the nylon set screws (Fig. 3) in the stop, so it is square and level with the table top.

The flip-away stop should not drag on the table top.

Fig. 2

Fig. 3