Access
the Service MenuTigerStop Manual
When upgrading a TigerStop controller
to a new software level,
a new enable code a series of numbers that you enter just once the first time you power
on your TigerStop, to activate it
must be assigned. To enable TigerStop for the use of the upgrade, the
enable code must be entered at the serial number parameter in the service
menu.
To enter a new enable code…
At the service menu 
press 
to select the Serial Number parameter.
The screen displays the TigerStop serial number and
the current enable code 
.
Press 
.
The display responds with 
.
Press 
to reset TigerStop for a new enable code.
Press to
exit the service menu 
.
Turn TigerStop OFF (Fig. 1) and wait for 5 seconds.
Turn TigerStop ON.
Continue at Step 2 in Enable
Your TigerStop.