Access
the Service MenuTigerStop Manual 4.72
The default zero end the end of the TigerStop fence closest to the saw or application machine,
opposite of home end, a functional designation of the TigerStop
for TigerStops is the motor end the end of the TigerStop fence closest to the motor box, opposite of
far end, a physical designation of the TigerStop.
The default zero end for TigerRip Fences
is the far end the end of the TigerStop fence farthest away from the motor box, opposite
of motor end, a physical designation of the TigerStop.
The zero end can be changed to the opposite of the default at the service menu, switching TigerStop's zero end from the motor to the far end.
It is unlikely that the zero end of TigerRip Fence would have to be switched, but it is possible to do this using the method described below.
To reverse the zero end…
At the service menu 
press 
to select the Zero
End parameter.
Press 
to toggle between the two choices…
|
|
|
|
Some TigerStops may display the choices shown below, using alternate terms drive end alternate (older) term for "motor end" and idle end alternate (older) term for "far end"…
|
|
|
|
When the desired zero end displays,
press 
to select
it.
TigerStop immediately runs the
Home routine.
Follow the prompts as usual during the Home routine. When the Home routine
finishes running, the display returns to the service menu .
To exit the Service Menu, press
.
