Deja el TigerStop Europa adaptar su sierra a formato, para que usted puede trabajar más rápido y preciso que nunca.

Steps 3-5

3
Robland specific: On the left end of the 50mm guide bar there is a set collar. Loosen this collar and slide it to the right. Later, after mounting the TigerRip Fence, you will use this to provide a physical stop to prevent accidental contact between the saw blade and the rip fence.
Mount the TigerRip Fence on the Guide Bar. With an assistant, raise the TigerRip Fence and hold it against the guide bar. Place the locking half of each bracket over the support half, insert the bolts and firmly tighten them. The TigerRip Fence can still be pivoted around the guide bar but will hold its position when moved. (The final positioning of the TigerRip Fence may not be at right angles to the floor.)

40mm Guide Bar specific: Some saws have a 40mm guide bar instead of the more usual 50mm. The universal suspension bracket has two types of support base for 50mm and 40mm guide bars. The locking half of the bracket is the same for both types. Installation procedure on a 40mm guide bar is exactly the same as for the 50mm shown in this guide. There will be a visible gap between the bar and the locking half when used on a 40mm guide bar.

4 Install the Pneumatic End Plate. Remove the motor box end plate and substitute the replacement end plate with the pneumatic components. The red air line should be pointing left towards the saw blade. Make the air connection. The regulator requires a 1/8" npt fitting. It is very important that the air supply is filtered dry air. If water gets into the air lines, the equipment cannot function correctly and will prematurely fail.

5 Attach the Fence Bracket. Remove the fine adjustment bracket from the existing rip fence, and set it aside. There are various types depending on the make of saw. Using the bolts and washers from the fine adjustment bracket or the bolts and washers provided in the accessory hardware pack, attach the L-shaped Fence Bracket through the appropriate slot(s). Firmly tighten down the bolts. (One bolt is sufficient as shown in the picture.)

Folgende Seite>

Seite 1 | Seite 2 | Seite 3 | Seite 4 | Seite 5

Descargarlo en formato PDF