Deja el TigerStop Europa adaptar su sierra a formato, para que usted puede trabajar más rápido y preciso que nunca.

The new TigerRip Fence kit includes our new patent pending bracket system. This system ensures that your TigerRip Fence is installed perfectly parallel to your existing fence guide bar.

0   Check your existing rip fence for misalignment. Before beginning the installation, inspect your existing saw for any misalignment between table and rip fence that might impede the movement or impair accuracy of the TigerRip Fence. A tell-tale sign of an out of alignment rip fence is abrasion marks on the saw table where the ripfence is hitting. If your saw table shows signs of abrasion, it is necessary to line up and level the table and existing rip fence to eliminate this problem before going on to install your TigerRip Fence.

1   Unpack your TigerRip Fence and its accessory parts. The TigerRip Fence is shipped clad in styrofoam and stretchwrapped. The accessories are shipped in a separate box. You will find all the parts pictured in the accessory box. If any part is missing, contact us immediately, and we will ship you the missing part at no charge. Parts & Quantities. See the enlarged photo of the contents of the accessory box on the front page.

2   Mount the Suspension Brackets on the TigerRip Fence extrusion. Insert two weld nuts into the u-channels on the top side of the extrusion. Slide one pair to the idle (far) end of the extrusion. Slide the other pair to about 7" from the motor end. The brackets have raised ridges designed to locate them relative to the u-channels. Position the first bracket over the pair of weld nuts at the idle end (nearest the saw blade).

Position the second bracket over the other pair of weld nuts at the motor end of the extrusion. Insert the socket head bolts and thread them into the weld nuts until they just catch.

Position the suspension brackets so they will be flush with each end of the rip fence bar when installed, as shown in the pictures below.

Carefully measure the distance and try to be accurate, because it is difficult to reposition the brackets on the extrusion after the unit is installed. When the brackets are in position, fully tighten the bolts.

Next Page >

pag. 1 | pag. 2 | pag. 3 | pag. 4 | pag. 5

PDF-formaat